This depends on your intentions for mixing. Input 6 was not receiving signal during recording. In this particular case, it was assigned to "Stereo VS-100 IN 5-6", but only Input 5 of our hardware (the Cakewalk VS-100) had signal present. The reason this happened is because the input of the track was assigned to a Stereo input source but it was only receiving signal from one input of the two inputs assigned. The right-channel is completely silent during playback because there was no signal present on this input of our audio hardware during recording. Also note that the playback activity meter of the track only shows signal in the left channel. If you look at the waveform, the left channel (top portion of the clip) has audio present, but the right channel (bottom portion of the clip) is a flat line (indicating silence). This particular track has a stereo audio file recorded, but only signal was present on the left channel. Let's break down the project above track by track. Tracks 1 and 2 are common mistakes and were recorded incorrectly, while tracks 3 and 4 were recorded correctly. In the image above, we have 4 audio tracks all with different material recorded. If you're wondering why this matters, allow us to explain a few beginner recording mistakes. Figuring this out before you begin to record will help you assign your track's inputs properly. On the other hand, if you are recording an external synthesizer with a stereo output or stereo overhead mics for a drum kit, you most likely will want to record a stereo audio file. Chances are, if you're recording a single microphone (such as for a vocalist or a guitar through a DI box), you will want to record a mono audio file. The answer to this always depends on your source. Instead, an audio track in SONAR will record a single channel (mono) audio file if it's input is assigned to a mono source or a two channel (stereo) audio file if it's input is assigned to a stereo input source.Īn important question you should always ask yourself before you begin to record is, "do you want to record a mono audio file or a stereo audio file?" In SONAR, audio tracks are not designated as "Mono" or "Stereo". As a result, these tracks can only record from a mono source or a stereo source depending on the type of audio track they are. In some recording applications, an audio track is designated as being a "mono" track or a "stereo" track when it is inserted. The information in this article applies to: Selecting Stereo versus Mono Inputs for Audio Tracks Last updated on
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |